Adjustable 1-10 Minute Timer Project
A kit for this project is available from
RSH Electronics.
The circuit starts timing when switched on. The green LED lights to show that timing
is in progress. When the time period is over the green LED turns off, the red LED turns
on and the bleeper sounds.
The time period is set by adjusting the variable resistor. It can be adjusted from
1 to 10 minutes (approximately) with the parts shown in the diagram. You can mark
the times on a scale drawn on the box.
Please note that the range of time periods is only approximate. With perfect components
the maximum time period should be 4½ minutes, but this is typically extended to
about 10 minutes because the 220µF timing capacitor slowly leaks charge. This is
a problem with all electrolytic capacitors, but some leak more than others. In addition
the actual value of electrolytic capacitors can vary by as much as ±30% of their
rated value.
This project uses a power-on triggered 555 monostable circuit.
Parts Required
- resistors: 470, 33k, 100k
- variable resistor: 1M
- capacitors: 0.1µF, 220µF 16V radial
- LEDs: red, green
- bleeper 9-12V
- 555 timer IC
- 8-pin DIL socket for IC
- on/off switch
- battery clip for 9V PP3
- stripboard 10 rows × 22 holes
Stripboard Layout
Circuit diagram
Sumber : http://www.kpsec.freeuk.com/
Tidak ada komentar:
Posting Komentar